An investigation of the occlusal surface of artificial teeth on complete dentures using finite element analysis and the optimization method

利用有限元分析和优化方法研究全口义齿的咬合面

• 批准号: 21592440
• 负责人: TAKAYAMA Yoshiyuki
• 金额: $ 3万
• 依托单位: Hokkaido University
• 依托单位国家: 日本
• 项目类别: Grant-in-Aid for Scientific Research (C)
• 财政年份: 2009
• 资助国家: 日本
• 起止时间: 2009 至 2011
• 项目状态: 已结题
• 来源: https://kaken.nii.ac.jp/grant/KAKENHI-PROJECT-21592440/
• 关键词: 全部床義歯; 人工歯排列; 有限要素法; 最適化; 無歯顎; 最適形状決定法; 咬合平面; 調節湾曲; 義歯の咬合; 顎堤形態; 人工歯咬合面形態

Optimization of the arrangement of artificial molars on complete dentures was performed with finite element analysis. The result for the arrangement of artificial molars on mandibular dentures showed that the occlusal surface should be parallel to the alveolar ridge surface below them. As to maxillary and mandibular complete dentures, the result depended on the response variable : maximum chewing efficiency in a specific teeth, or maximization of the lowest chewing efficiency of all teeth. The method in this study was considered to have a potential usefulness for the determination of the arrangement of artificial teeth.

通过有限元分析对全口义齿上的人工磨牙的排列进行了优化。下颌假牙上人工磨牙的排列结果表明，咬合面应与其下方的牙槽嵴面平行。对于上颌和下颌全口义齿，结果取决于响应变量：特定牙齿的最大咀嚼效率，或所有牙齿的最低咀嚼效率的最大化。本研究中的方法被认为对于确定人造牙齿的排列具有潜在的用途。

项目成果

Morphological factors of residual ridges determining stability of complete dentures

决定全口义齿稳定性的残牙槽嵴形态因素

• 发表时间: 2010
• 作者: Takayama Y;Sasaki H;Goto M;Saito M;Yokoyama A
• 通讯作者: Yokoyama A